A leaky roof is almost as annoying as it can be destructive. You want to jump into action right away to take care of this problem. While there are many ways you could do this, liquid EPDM is going to be the best for RV Roof. This is how you apply it.
Make Sure You’ve Found the Source of the Leak
This is the most important step in properly repairing your roof. Though it sounds obvious, roof leaks can be tricky and if you don’t handle this step correctly, the rest of it won’t matter much.
Depending on the extent of the damage done, this might be easy enough to do. There could be multiple sources of the leak, though. If you can’t clearly identify the origin of the leak from the stains in your RV roof, you’ll want to do some looking.
Likewise, even if it appears evident enough, you could have multiple roof leaks so, again, look around a bit to make sure there isn’t more than one that will need repairs.
Clean the Area of Debris
Once you’ve identified all the roof leaks, you’ll need to do a bit of cleaning. You want to make sure that debris and dust won’t stand between the seal of your EPDM and your roof.
Even small spaces in the seal can be enough to let water in after you thought the repair was done.
Use a brush to get all the debris out of the way. If there is extensive structural damage, you’ll want to have that repaired before you add your liquid EPDM. Check the side of your liquid EPDM container to make sure you have enough for the job.
Mix Your Liquid EPDM and Apply It to Your RV Roof Leaks
Now, you’re ready to begin. Mix the liquid EPDM with water according to the directions on its container. If you’re using a spray or some seals, this won’t be an issue. Again, just follow the directions to properly apply it.
Otherwise, you’re going to mix it and then apply the liquid EPDM just like you would paint. It can be applied to flat or slanted surfaces.
Once your project is done, the EPDM will be ready to put up with strong winds, rain and snow in about a day. It cures best in 55 degrees or above, but temperature isn’t a huge requirement. Liquid EPDM will settle in any climate.
That’s all there is to it. The leaks in your roof are now completely sealed and will no longer be a problem.